Roseville Repipe
Skip to main content

Roseville Repipe: Slab Leak Repair in Roseville, CA

A slab leak is a leak in a water line under the concrete floor of your house. Roseville Repipe does slab leak repair in Roseville, CA. We find the leak, then fix it one of two ways: run a new line overhead through the attic and walls, or open the slab and fix the pipe in that spot.

Monday to Saturday, 7:00 AM to 7:00 PM

Get a Free Repipe Quote

By submitting, you agree to our Privacy Policy and Terms of Service.

What is a slab leak?

Many homes in the Roseville area are built on a concrete slab, with some water lines running under or inside the concrete. A slab leak happens when one of those lines springs a leak. The water goes into the soil and the slab instead of coming out where you can see it.

Hot water lines leak under slabs more often than cold lines, because hot water and the heating and cooling of the pipe put more wear on it. That's why a warm spot on the floor is one of the best-known signs.

What are the signs of a slab leak?

  • A warm or hot spot on the floor, often felt with bare feet
  • The sound of running water when everything is turned off
  • A water bill that jumps for no reason
  • The water meter moving when no water is on
  • Damp carpet, a wet pad, or warped wood flooring
  • A musty smell or mildew near the floor or baseboards
  • New cracks in the floor or walls
  • The water heater running more than it used to

One easy test: turn off every faucet, appliance, and sprinkler. Then look at the water meter. If the dial or leak indicator is still moving, water is going somewhere. That doesn't prove it's a slab leak, but it means it's time to find out.

How do you find a slab leak?

You find it before anyone breaks concrete. We start by confirming there's a leak and narrowing down which line it's on. Then we pinpoint where it is. See leak detection for how that works.

Knowing which line is leaking matters as much as knowing where. A leak on a hot line near the kitchen and a leak on a cold line near the front of the house can lead to two very different fixes.

Should you reroute the line or repair it in the slab?

There are two main ways to fix a slab leak. Here's how they compare:

Slab leak reroute vs. direct repair
RerouteDirect repair
What we doAbandon the bad line and run a new one through the attic or wallsBreak open the floor at the leak and fix that section of pipe
Floor damageNone to the slabA hole in the floor and flooring to replace
Wall and ceiling openingsSmall access cuts to drop the lineUsually none
Best forOlder pipe, long runs, or repeat leaksNewer pipe and one easy-to-reach leak
After the fixThe new line is up where you can reach itThe rest of the old line is still under the slab

A reroute is often the better long-term fix when the pipe is older. If one spot under the slab leaked, the rest of that line is the same age. A direct repair can make sense when the pipe is newer, the leak is in an easy spot, and the flooring there is cheap to replace.

We'll show you both options and tell you which one we'd pick for your house.

Can a slab leak mean you need a repipe?

Sometimes. One slab leak can be a one-time problem. Two or three in a few years usually means the pipe is wearing out. At that point, a partial repipe of the lines under the slab, or a whole house repipe, can save you from chasing leaks one at a time.

Most of our slab reroutes and repipes use PEX repiping, because it bends through the attic and down the walls with fewer openings.

What happens to the walls and floors after a slab leak?

A reroute leaves small access cuts in walls or ceilings. A direct repair leaves a patch of concrete and flooring to fix. We patch the drywall openings with drywall repair after repipe. Flooring replacement after a direct repair is a separate trade.

If the leak ran for a while, the area may need drying out. Wet drywall, carpet pad, and insulation can grow mold if they stay wet.

What does slab leak repair cost?

It depends on how the leak gets fixed, how long the reroute is, and how much wall or floor has to open. A direct repair also includes concrete and flooring work. For more on what drives repipe and leak costs, see our Roseville repipe cost guide, and read slab leak signs and options for the full rundown.

Slab leak repair FAQs

Is a slab leak an emergency?

It can be. If you see water coming up through the floor or the meter is spinning fast, shut off the main water valve and call. A slow leak still needs attention soon to limit damage.

Can you fix a slab leak without breaking the floor?

Yes, with a reroute. We abandon the leaking line and run a new one through the attic and walls.

Does homeowners insurance pay for slab leaks?

It depends on your policy. Some cover water damage and access to the leak but not the pipe repair. Call your agent before work starts.

Will another slab leak happen?

If the rest of the pipe is old, it can. That's why rerouting or repiping is often the better long-term fix.

How long does a slab leak repair take?

Many reroutes are done in a day. A direct repair can take longer because of the concrete and flooring.

Do I need a permit for a slab leak repair?

Replacing or rerouting water piping is new work under the plumbing code, so plan on a permit and inspection. Your city sets the details.

Related services

Areas we serve

Warm spot on the floor?

Call us. We'll find the leak and give you your options before anything gets torn up.

Get a Free Repipe Quote

By submitting, you agree to our Privacy Policy and Terms of Service.

Call NowFree Quote