Roseville Repipe
Skip to main content

Roseville Repipe: Partial Repipe in Roseville, CA

Not every house needs a whole house repipe. Roseville Repipe does partial repipes in Roseville, CA when only one part of the plumbing is bad: one bathroom, the kitchen, one wing of the house, or a line under the slab. We replace what needs it and tie it into the pipe that stays.

Monday to Saturday, 7:00 AM to 7:00 PM

Get a Free Repipe Quote

By submitting, you agree to our Privacy Policy and Terms of Service.

What is a partial repipe?

A partial repipe replaces one section of the water supply lines in the house instead of all of them. The rest of the plumbing stays.

Common partial repipes we do:

  • One bathroom group: the sink, toilet, and tub or shower in one bathroom
  • The kitchen: sink, dishwasher, refrigerator line, and sometimes the laundry
  • One side of the house, like a bedroom wing or a converted garage
  • The hot side only, when only the hot lines are failing
  • A line under the slab, rerouted through the attic or walls
  • The lines in and out of the water heater

When does a partial repipe make sense?

A partial repipe is the right call when the trouble is in one place and the rest of the pipe is in good shape. Here's when it usually fits:

  • A slab leak on one line, and the rest of the copper looks healthy
  • A remodel that already has the walls open in one room
  • Leaks that keep showing up in one bathroom but nowhere else
  • An addition that was plumbed with a different pipe than the rest of the house
  • Old pipe left in one area after someone repiped part of the house years ago

When should you do the whole house instead?

Sometimes a partial repipe is just paying twice. If leaks are showing up in different parts of the house, the problem is the pipe, not one spot. Here's when we'd tell you to look at a whole house repipe:

  • Galvanized pipe that's rusted all through the house
  • Polybutylene pipe anywhere in the house
  • Pinhole leaks in more than one area in a short time
  • Low pressure everywhere, not just at one fixture
  • You plan to stay in the house a long time and want it done once

A lot of the cost of a repipe is getting set up, opening walls, and patching them. Doing the whole house at once often costs less than doing it in three pieces over a few years. We'll give you both prices so you can decide.

How do you tie new pipe into old pipe?

With the right fittings and a good look at the old pipe where we tie in. That joint is where a partial repipe can go wrong if it's not done right.

  • New PEX to old copper: a transition fitting made for the job
  • New copper to old copper: soldered or press fittings
  • New pipe to old galvanized: a dielectric fitting to keep the two metals from corroding where they meet

We also check the old pipe right at the tie-in point. If it's thin, corroded, or cracks when we work on it, we'll show you and talk about going further.

Can a partial repipe fix a slab leak?

Often, yes. When a line under the slab leaks, one fix is to stop using that line and run a new one over the top through the attic and walls. That's a partial repipe on one line. It's often called a slab leak reroute.

It's usually less work than cutting into the floor, and the new line is up where you can get to it later. Read more on slab leak repair. If you know water is going somewhere but don't know where, start with leak detection.

What pipe do we use for a partial repipe?

Most partial repipes use PEX, because it bends and needs fewer wall openings. If the rest of your house is copper and you want it to match, we can use copper. Compare the two on PEX repiping and copper repiping.

What does a partial repipe cost?

Less than a whole house repipe, but not always by as much as people expect. Setup, permits, wall openings, and drywall patching are part of every job. The price depends on how many fixtures, how far the lines run, and how much wall has to open. See our Roseville repipe cost guide.

Partial repipe FAQs

Is a partial repipe cheaper than a full repipe?

Yes, for the job itself. But if the rest of the pipe fails a few years later, doing it in pieces can cost more in the end.

Does a partial repipe need a permit?

Yes. Replacing water piping is new work under the plumbing code, so it gets a permit and an inspection.

Can you repipe just one bathroom?

Yes. A single bathroom group is one of the most common partial repipes we do.

Will the new pipe work with my old pipe?

Yes, with the right transition fittings. We check the old pipe where we tie in so the joint holds.

Can I do a partial repipe now and the rest later?

Yes. Some people repipe the worst part first and finish later. We'll lay it out so the rest is easy to tie in.

How long does a partial repipe take?

Many are done in a day. Bigger sections can take longer. We'll tell you when we quote.

Related services

Areas we serve

Only one part of the house giving you trouble?

Call or tell us where the leaks are. We'll tell you if a partial repipe will do it.

Get a Free Repipe Quote

By submitting, you agree to our Privacy Policy and Terms of Service.

Call NowFree Quote