Signs Your Home Needs a Repipe
Pipes don't usually fail all at once. They give you warnings first. Here are the signs we look for, what each one usually means, and when it's time to stop patching and start talking about a repipe.
Last updated: November 18, 2026
Monday to Saturday, 7:00 AM to 7:00 PM
What are the most common signs you need a repipe?
- More than one leak in a year or two
- Low water pressure at more than one fixture
- Brown, red, or yellow water
- Water that smells or tastes metallic
- Gray plastic polybutylene pipe anywhere in the house
- Gray steel galvanized pipe that's rusting
- Green or white crust on copper pipe or fittings
- Pipes that bang, rattle, or whistle
- A water bill that went up with no change in use
One sign by itself doesn't always mean a repipe. Two or three together usually do.
Why do repeat leaks matter so much?
Because one leak tells you about the pipe it came from, and the rest of the pipe is the same age and the same material. A pinhole leak in copper is often the first of several. A cracked polybutylene fitting is a warning about every other fitting in the house.
Every leak also costs more than the repair. Water gets into drywall, insulation, cabinets, and floors. A leak inside a wall or ceiling can run a long time before anyone sees it. If you've had two or three leaks in a short time, it's usually cheaper to repipe than to keep fixing.
What does low water pressure tell you?
It depends on where it shows up.
| Where it's low | What it often means |
|---|---|
| One faucet only | A clogged aerator or a bad valve at that fixture |
| Hot water only | A problem at the water heater or the hot lines |
| One bathroom or one side of the house | A choked or leaking section of pipe |
| Every fixture in the house | Old galvanized pipe, a failing pressure regulator, or a main line problem |
| Upstairs only | Undersized or scaled-up pipe feeding the second floor |
Low pressure everywhere in an older house with galvanized pipe is one of the clearest signs of a repipe. Rust builds up inside the pipe and narrows the opening until not much water gets through. See galvanized pipe replacement.
What does rusty or discolored water mean?
Brown or red water usually means rust. If it's worst first thing in the morning or after the water's been off, it's often coming from rusted galvanized pipe inside the house. If it shows up on hot water only, the water heater may be the source.
Discolored water can also come from work on the water supplier's mains in the street. If your neighbors see it too, call your water supplier first. If it's just your house and it keeps happening, it's likely your pipe.
Which pipe types are most likely to need replacing?
- Galvanized steel: rusts from the inside. Low pressure and brown water are the classic signs.
- Polybutylene: gray plastic pipe, often stamped PB2110. The big class action over it covered polybutylene plumbing installed between January 1, 1978, and July 31, 1995. It's known for cracking without warning.
- Older copper: can develop pinhole leaks over time, often more than one.
If you're not sure what you have, look at the pipe coming out of the wall at your water heater and under your sinks. See polybutylene pipe replacement for help telling them apart.
Does the age of a Roseville home matter?
Yes, as a starting point. Roseville's oldest homes are near downtown and the older neighborhoods around it, and those are the most likely to have old galvanized pipe. Census survey estimates for the Roseville City School District area put about 13% of homes before 1970 and about 37% from 1970 to 1999. Homes from the late 1970s to the mid 1990s were built during the years polybutylene was sold.
Age isn't the whole story, though. A 1960s house that was repiped 15 years ago may be fine. A 1990s house with pinhole leaks may not be. The pipe tells you more than the date on the deed.
What should you do if you see these signs?
- Look at the pipe where you can see it and take a photo.
- Do a meter test: turn off all water in the house and see if the meter keeps moving.
- Write down where and when any leaks happened.
- Note where pressure is low and whether it's hot, cold, or both.
- Call for a look before the next leak becomes water damage.
If you think water is leaking somewhere you can't see, start with leak detection. If the signs point to the whole system, see our main page on whole house repiping in Roseville.
Signs of a repipe FAQs
How many leaks before I should repipe?
Can a home inspector tell if I need a repipe?
Is green crust on copper pipe a problem?
Why do my pipes bang when I turn off a faucet?
Does brown water mean I need a repipe?
Should I repipe before I sell my house?
Seeing more than one of these signs?
Call or send a few details. We'll look at the pipe and tell you straight if it's time.